Post by Kerstin on Apr 16, 2020 16:27:30 GMT
Hi,
I have a set of instructions at the start of the block and want users to press 'enter' to continue. However, while compile is happy with the code, when I try to run, it gets to the instruction and goes no further, no matter which key I press
The code I'm using is (P3I is the bitmap)
block 3Pos
message P3I enter
tasklist ….
If I change the word enter to the letter b, it runs fine when I press b.
My instruction image says Enter so just want to double check as the list of special keys, suggests that enter should be fine. If it isn't then I'll change the instruction image.
Thanks
I have a set of instructions at the start of the block and want users to press 'enter' to continue. However, while compile is happy with the code, when I try to run, it gets to the instruction and goes no further, no matter which key I press
The code I'm using is (P3I is the bitmap)
block 3Pos
message P3I enter
tasklist ….
If I change the word enter to the letter b, it runs fine when I press b.
My instruction image says Enter so just want to double check as the list of special keys, suggests that enter should be fine. If it isn't then I'll change the instruction image.
Thanks
