|
Post by stoptask on Apr 16, 2020 11:49:36 GMT
"Following conventionally accepted procedures, the SSD was adjusted following each stop trial to ensure that roughly half of stop signals resulted in commission errors (Osman et al., 1986, 1990). That is, successful response The inhibition on one stop trial led to an increase in the SSD on the next stop trial, with each successive stop trial increasing in difficulty until inhibition failed (at which point the SSD was subsequently reduced)."
Is there anyway I can do this in psytoolkit? Like use the stopsignal delay and whether the trial is correct or not in the next trial?
|
|
|
Post by PsyToolkit on Apr 16, 2020 15:29:33 GMT
Absolutely. You can store the RT or any other number in a variable and use that in the next trial. Look at the set instructions on how to do that:
|
|